how do you change the front wheel bearings on a 1996 honda passport?

10-21-2007

I need to know how to change my front wheel bearings on my 1996 honda passport 4 wheel drive

10-21-2007

The bearings are pressed into the uprights, so you need to take the front upright off the vehicle, press the old bearings (2) out and press two new ones in and reassemble.

10-21-2007

Disconnect the caliber,pull off the rotor,remove the axle nut,remove the bearing assemble bolts(3or4bolts)hammer off the old bearing assemble,the lug nut studs are part off the bearing hub.Reverse the process for the new one

10-22-2007

it may just be easier to replace the whole hub and bearing assembly. it may cost more but i don't know because im not familiar with honda.

10-21-2007	#1 (permalink)
*jb* Guest Posts: n/a	how do you change the front wheel bearings on a 1996 honda passport? I need to know how to change my front wheel bearings on my 1996 honda passport 4 wheel drive

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Ive got a 1996 Honda CB750 Nighthawk and was wondering if there is a way to	zanderhunt	Honda	0	10-22-2007 07:44 PM
how to change the mototrcycle oil for honda cbf125z full japanese import?	barathiraja2003	Honda	0	10-20-2007 02:16 PM
I have an Intergra Honda 1996 , the floor stays wet any answers.?	Deannie	Acura	0	10-16-2007 08:21 PM

10-21-2007	#2 (permalink)
rex_rrracefab Guest Posts: n/a	The bearings are pressed into the uprights, so you need to take the front upright off the vehicle, press the old bearings (2) out and press two new ones in and reassemble.

10-21-2007	#3 (permalink)
jasonbatla Guest Posts: n/a	Disconnect the caliber,pull off the rotor,remove the axle nut,remove the bearing assemble bolts(3or4bolts)hammer off the old bearing assemble,the lug nut studs are part off the bearing hub.Reverse the process for the new one

10-22-2007	#4 (permalink)
mike l Guest Posts: n/a	it may just be easier to replace the whole hub and bearing assembly. it may cost more but i don't know because im not familiar with honda.