Peugeot 106 torsion bar suspension ?

10-18-2007

Hi, i am trying to adust the torsion bar on one side of my 1995 106 diesel. its sitting really low on the right side at the rear. but everything seems in order its just the position the torsion bar is set at that i suspect someone has done wrong as i just got the car. but i can't get it off!! what holds the swing arm on?? i have the torx bolt out of the torsion bar but can't find anything else holding the swing arm on! how do i release it to get the torsion bar out and back in on a better setting?

10-18-2007

use a slide hammer attached to the original torx bolt

10-18-2007

use a slide hammer attached to the original torx bolt

10-18-2007

use a slide hammer attached to the original torx bolt

10-18-2007	#1 (permalink)
Joe J Guest Posts: n/a	Peugeot 106 torsion bar suspension ? Hi, i am trying to adust the torsion bar on one side of my 1995 106 diesel. its sitting really low on the right side at the rear. but everything seems in order its just the position the torsion bar is set at that i suspect someone has done wrong as i just got the car. but i can't get it off!! what holds the swing arm on?? i have the torx bolt out of the torsion bar but can't find anything else holding the swing arm on! how do i release it to get the torsion bar out and back in on a better setting?

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
When I turn my 1997 Lincoln Towncar off the air in the air suspension goes down why?	tony_leroy	Lincoln	1	10-19-2007 09:11 PM

10-18-2007	#2 (permalink)
TANYA T+o Guest Posts: n/a	use a slide hammer attached to the original torx bolt

10-18-2007	#3 (permalink)
TANYA T+o Guest Posts: n/a	use a slide hammer attached to the original torx bolt

10-18-2007	#4 (permalink)
TANYA T+o Guest Posts: n/a	use a slide hammer attached to the original torx bolt